Table of Contents
Advertisement
extended shut down of the vehicle. Please
contact Dometic Customer Services.
Explanation of operating controls
(Power on switch/energy selector switch
(MODE)
Temperature selection
Power On switch frame heating
Indicator LED failure
Indicator LED frame heating
Indicator LED/operating mode display
Temperature level display.
NOT APPLICABLE
External display "failure" (red)
External display "in operation" (blue)
Explanations
The refrigerator is equipped to operate on
mains power, 12v DC or liquid gas. Select the
desired power supply by turning the energy
selector switch (1).
The energy selector switch (1) has four
settings: Off, mains voltage (230v AC), direct-
current voltage (battery, 12v DC), gas (liquid
gas propane/butane)
Switch the refrigerator ON or OFF by pressing
button (1) for 3 seconds. Button (1) allows you
to either initiate the requested energy supply
or activate dimming of the LED brightness. By
pushing once, the indicators illuminate for 10
seconds.
Button (3) allows you to switch on the
frame heating in order to avoid a rising of
condensation water due to high humidity.
During the frame heating operation the
indicator LED (5) is illuminating.
Electrical Operation
MES Appliances (manual energy selection)
To start the refrigerator, press button (1) for
3 seconds.
The LED (6) of the previously selected
operating mode illuminates:
230v operation
12v operation
Gas operation
Change the operating mode by pressing
button (1) again. The appropriate indicator
LED will illuminate.
Press button (1) several times until the
indicator LED (6) illuminates.
The ignition process is activated automatically
by means of an automatic igniter.
The ignition system will make 2
i
ignition attempts with 25 seconds
interval when the burner fails to light.
If repeated attempts fail to start the
operation, a fault is indicated (please
refer to failure indication found on
page 109).
Setting
of
The
Temperature
Select the desired cooling compartment
temperature by pressing button (2).
The LED display (7) of the selected
temperature setting is illuminated.
The scale starts with MIN position at the
bottom LED position (small crystal = highest
temperature) and climbs up to MAX position
at the upper LED position (largest crystal =
lowest temperature). Note: The temperature
levels do not relate to absolute temperature
values.
Cooling
Compartment
115
Advertisement
Table of Contents
Troubleshooting
