Whale Submersible Pump - Bailey Approach Autograph Series Owner's Manual

38
To Remove the Whale Aquasource
1. Disconnect the Whale Aquasource from
the tap.
2. Lift the lid of the Whale Watermaster
socket to the vertical position.
3. Depress the two white location buttons on
the Whale Watermaster plug and remove
from the socket.
4. Close the lid of the Whale Watermaster
socket.
5. Stow away the Whale Aquasource in a
clean chemical-free area.
CAUTION: When you are using the
Aquasource system it is important
that you do not leave the vehicle
unattended without turning the
water source off at the supply point.

Whale Submersible Pump

The Submersible pump is designed to run when
fully submerged in water. It pumps water from
an aqua roll container to the fresh water tank,
2.5 aqua rolls will fill the tank.
To install the Whale Submersible Pump
1. Fill a suitable water container and place
below the Whale Watermaster socket.
(located on the offside wall of the
motorhome).
2. Place the Whale Submersible pump into
the water container. The pump should
reach the bottom of the container.
3. Lift the lid of the external Whale
Watermaster socket.
4. Insert the Whale Submersible pump plug
firmly into the socket and close the lid
down until it locates and locks the pump
plug into place.
5. The pump will automatically pump water
into the fresh water tank.
6. When the onboard tank is full the pump will
turn off.
7. To remove the Whale Submersible pump.
Lift the lid of the Whale Watermaster
socket into the vertical position.
8. Remove the Whale Submersible pump plug
from the Whale Watermaster socket.
9. Close the lid of the Whale Watermaster
socket.
CAUTION: When the water container
is empty the pump will continue to
run.
NOTE: The maximum continuous
operation should not exceed 15
minutes.
It should be noted that as the container volume
is likely to be less than that of the onboard tank,
it is advisable to remain in attendance when
filling the tank as the life of the pump will be
drastically reduced, if allowed to run dry. To fill
an onboard tank to the brim you normally have
to repeat this procedure several times.
Should the motorhome be left unattended, or
the water supply has run dry, switch off the
power supply to the pump via the control panel
to avoid continious running.