14C. The Pursuit Water System; Truma Ultraflow Instructions; Routine Maintenance; Sterilising - Bailey Pursuit Owner's Manual

14c. THE PURSUIT WATER SYSTEM

Truma Ultraflow Operating Instructions
Raise the lid, clean both the water socket and
the plug of the pump assembly.
Plug the pump connector into the socket.
Place the pump into the water container,
ensuring that it is fully submerged before
operating the system. The dust cover (8) is
to stop contaminates falling into the water
container.
To remove the pump assembly from the
Ultraflow Compact Housing, pull the trigger
and pull out the hose plug.
Do not remove by pulling the hose
or electrical cable.

Routine Maintenance

Ensure that the O-ring seals in the hose plug
and the socket are free from dirt.
To aid fitting of the plug assembly smear the
O-ring with vegetable oil.
Notes
Never allow the pump to run dry. Always
ensure that the pump is submerged in the
water or the life of the pump will be reduced.
Before winter storage the water system must
be completely drained.
Clean the water system at the start and end
of the season with sterilising fluid (see notes
below).
If the pump fails to deliver water, the most
likely cause will be air in the system. Switch
off the pump and shake the pump assembly in
the water. Then switch on the pump again.

Sterilising

When cleaning the water system at the start
or end of the season it is advisable to use non-
chlorine-based sterilising fluid.
Flush the system thoroughly to remove the
effective fluid traces.
41