Bailey Pursuit Owner's Manual page 63

Operating the Water Heater
1. From the home screen, touch the "tap" icon.
2. The following screen will appear;
3. Select the desired setting by touching one
of the following icons. The icon will turn red to
show it has been activated.
*Low electric setting. This uses 750W
(3.25A). Unlike the heat boost settings**,
the low setting does not operate on a timer,
therefore the timer function will remain at
0. When this setting is enabled the water
heater will remain CONSTANTLY ON until all
water heater settings are turned off. The low
electric setting is best used when the vehicle
is connected to a mains supply with limited
current capacity.
NB: Running several appliances at once will
increase the current drawn by the van, which
,depending on the rating of the circuit breaker,
could trip the supply. If several appliances are
running at the same time, the low electric
setting can be used to heat the water but
with a reduced current draw. Please note the
calculated amp value on the iVan control panel
only shows the current drawn by the Whale
heating system, and does not measure other
appliances within the van.
** Heat Boost settings: There are a number
of settings which can be used depending on
the desired power/gas usage and the required
heat up timer. When using any of these
combinations the timer will count down for
15 minutes (default). If a larger supply of hot
water is required, over a longer period of time
e.g. if 3 or more showers are required in quick
succession, the timer function can be changed
to 30 mins, 45 mins, 60 mins or forever.
NB: After the boost time has reached 0, the
water heater will automatically return to the
previous setting.
To change the default timer function, touch
the spanner icon on the home screen, then
the options icon and use the arrow keys to
scroll through to "Water Heater Boost Time"
Select the desired boost timer duration using
the - and + Note: If "Forever" is selected the
water heater will remain CONSTANTLY ON
until all water heater settings are turned off.
4. Once the desired setting has been activated,
press the home button to return to the home
screen.
The home screen will now show the "tap" icon
in red with selected heat setting displayed.
51