Table of Contents
Advertisement
A.1.9 NextMove PCI CAN Bracket board
Catalog
number
OPT030-501
A.1.10 Encoder Splitter/Buffer board
This is a stand alone PCB that takes an encoder signal, either single ended or differential and
gives differential outputs. This is useful for 'daisy chaining' an encoder signal from a master
across a number of controllers.
Catalog
number
OPT008-501
OPT029-501
MN1903
This is a compact alternative to using the breakout module when the
NextMove PCI controller is being used only as a CAN network
manager. Both CAN channels are presented on 9-pin D-type
connectors. The board is connected to the NextMove PCI CAN
jumpers by a ribbon cable.
The CAN1 (CANopen) channel is presented on a 9-pin male D-type
connector and is fitted with the isolated CAN transceiver module.
A supply of 12-24V (60mA) must be connected to CAN1 V+ and
CAN1 GND (see section 4.6).
The CAN2 (Baldor CAN) channel is presented on a 9-pin male D-type
and is fitted with the non-isolated CAN transceiver module.
Terminators J4 (Baldor CAN) and J5 (CANopen) are provided for
terminating the CAN networks. There should be terminators at the
both ends of each network and nowhere else.
Description
CAN bracket assembly - alternative to breakout module for CAN
connections only
Description
2-way encoder splitter - allows a single-ended or differential encoder pulse
train to be shared between two devices
4-way encoder splitter - allows a single-ended or differential encoder pulse
train to be shared between four devices
Accessories A-7
Advertisement
Table of Contents
