Table of Contents
Advertisement
6.2 NextMove PCI indicators
6.2.1 Status and CAN LEDs
The backplate of the NextMove PCI contains four LEDs. S1 and S2
represent general status information. C1 and C2 are CAN traffic
indicators. The LEDs may illuminate red or green and can be
continuous or flashing.
LED State(s)
All off
All red
All green,
cycling
All red,
cycling
S1 green,
flashing
S1 red,
flashing
S1 red,
flashing fast
S1 green,
flashing fast
All green,
flashing
All red, turn off
in sequence:
C1, S1, S2, C2
C2 green,
flashing
6-2 Troubleshooting
Meaning
NextMove PCI is not powered.
In hardware reset (see section 4.8).
In software reset, with no errors (see section 4.8).
In software reset, Power On Self Test (POST) error has occurred.
Program is running OK.
Program is running, but there is an initialization error.
Asynchronous error - for example, a limit switch has been activated.
Miscellaneous error - for example, the output driver board is not
working.
Updating firmware.
POST is in operation (after reset).
Message received on CAN2 bus.
C1
C2
S1
S2
MN1903
Advertisement
Table of Contents
