Table of Contents
Advertisement
3.1 Introduction
You should read all the sections in Basic Installation.
It is important that the correct steps are followed when installing the NextMove PCI.
This section describes the mechanical and electrical installation of the NextMove PCI.
3.1.1 Hardware requirements
The components you will need to complete the basic installation are described below:
A PC that fulfills the following specification:
H
Processor
Hard disk space
3.1.2 Tools and miscellaneous hardware
Your PC operating system user manual might be useful if you are not familiar with Windows.
H
A small cross-head screwdriver for fitting the card.
H
3.1.3 Other information needed for installation
You will need the following information to complete the installation:
Knowledge of which digital inputs/outputs will be 'Active Low' or 'Active High' to meet the
H
requirements and specification of the system you are going to build.
MN1903
Minimum specification
Intel Pentium 133MHz
RAM
CD-ROM
Screen
800 x 600, 256 colors
Mouse
Operating
system
PCI slot
3
32MB
40MB
A CD-ROM drive
A mouse or similar pointing device
Windows 95, Windows 98, Windows ME,
Windows NT, Windows 2000 or Windows XP
One spare PCI slot
Basic Installation
Recommended specification
Intel Pentium 200MHz or faster
64MB
60MB
1024 x 768, 256 colors
Basic Installation 3-1
3
Advertisement
Table of Contents
