5.1.4 Installing WorkBench v5
You will need to install WorkBench v5 to configure and tune the NextMove PCI.
1. Insert the CDROM into the drive.
2. After a few seconds the setup wizard should start automatically. If the setup wizard does not
appear, select Run... from the Windows Start menu and type
d:\start
where d represents the drive letter of the CDROM device.
Follow the on-screen instructions to install WorkBench v5. The setup Wizard will copy the files
to appropriate folders on the hard drive. The preset folder is C:\Program Files\Baldor\MintMT,
although this can be changed during setup.
MN1903
Operation 5-3