Voice Message(S) Recording; Telephone Dialer Testing; Dialing Method; Telephone Dialer Triggering - jablotron MAESTRO JA-65 Installation Manual

14.2. Voice message(s) recording

The existing message(s) can be played by momentarily pressing the push button on the 65X module.
To record your voice message, enter 84 on the keypad and then press and hold the push button on the 65X module while
talking into the 65X microphone (max. 20 seconds). After releasing the button, the message will play back. The message
is stored in non-volatile memory and can be changed when ever you want to by repeating the above steps. Make the
message clear and brief. The dialer repeats the message to each called number for 40 seconds.
It is possible to split the voice message into two different messages (10 seconds each). Depending on the setting in
section 14.5., a particular message will be sent under different situations.
If you want to record two messages (max. 10 seconds each): enter 85 on the keypad and then press and hold the push
button on the 65X module to record the first message. To record the second message enter 86 on the keypad and then
press and hold the push button on the 65X module.

14.3. Telephone dialer testing

Entering 89 and the dialer will call the programmed numbers once. You will hear the telephone line signals from the
control panel built in speaker during the test (if the dialer is triggered by an alarm in normal operation, it will call silently).
Testing can be terminated with the N key.
If two different voice messages were recorded, then use sequence 88 to test the sending of the first message and 89 to
test the sending of the second message.

14.4. Dialing method

Enter:
9 0 1
9 0 0
Note: this dialing method setting is also valid for Monitoring station communications as well as remote PC access
Factory default: tone dialing

14.5. Telephone dialer triggering

With sequences 91x to 95x you can select which alarms will trigger the telephone dialer to call and which ones will not.
Enter:
9 y x
where
Example: if the dialer should not call when the system is tampered, enter 940
Factory default setting: all alarms will trigger the dialer (it means 911, 921, 931, 941 & 951)
If two different voice messages were recorded (see 14.2.), then parameter x specifies which message will be sent.
Reaction
x
0 not to call
1 send message #1 and Pager code
2 send message #2 only
3 Send Pager code only

14.6. Telephone line checking

If this function is enabled, the dialer will check regularly if the telephone line is ready to make a phone call. If the line is not
ready for more than 15 minutes, the keypad will indicate a telephone line failure (failure L). The failure will also be
indicated, if you make (or receive) a phone call or fax longer than 15 minutes.
options:
9 9 1
9 9 0
Note: this setting is also valid when the dialer is used for Monitoring station communications as well as remote PC access
Factory default setting: checking disabled
Alarm system JA-65 MAESTRO
for tone dialing
for pulse dialing (this option is blocked for some countries)
y Alarm x
1 Panic – silent 0
2 Intruder 1
3 Fire 2
4 Tampering 3
5 Technical trouble
checking enabled
checking disabled
reaction
not to call
voice message & Pager code
voice message only
Pager code only
- 18 -
sequence: 8 4
sequence: 8 9
sequence: 9 0 x
sequences: 9 y x
sequence: 9 9 x
MFM51202