Real Time And Date Setting; New Service Code Setting; Telephone Numbers Entering; Voice Message Recording - jablotron JA60K Installation Manual

7.2.21. Real time and date setting

The control panel has a built in real time clock. All events are stored to the event memory including the time of the event.
The clock should be set after the installation is complete.
Time Setting:
4 hh mm dd MM YY
where
Example: on Jun. 30 2001 at 17:15 enter: 4 17 15 30 06 01
After the control panel is powered, its internal clock's default setting is: 00 00 01 01 00
Note: detail control panel event history can be viewed with a connected PC using ComLink software.

7.2.22. New service code setting

The Service Code can be used to enter the programming mode. A new Service Code must be entered twice in the se-
quence to avoid an error.
To change the code enter:
Example: to change service code to 1276 enter: 5 1276 1276
Factory default setting: service code is 6060

7.2.23. Telephone numbers entering*

Store telephone numbers for voice message entering:
7 xx... xx F y
A telephone number can have a maximum of 16 digits. A pause can be entered with F0
digit).
Example: to store tel. number 02-123456 to memory no. 2 enter: 7 02 F0 12345 F2
Note: enter a pause (F0) after the last digit of a number which is calling a mobile phone. This way the number will be
called only once and the dialer will not check the line signals. (some mobile phone systems do not generate standard
telephone line signals).
When activated, the dialer will disengage all other devices hooked up to the phone line (telephone, fax..). It will then,
one by one, call and play the user recorded message, for all programmed numbers. If the dialer makes a successful
connection to a programmed number, it will not call that number again. If the number is busy, the dialer will make 3 more
attempts to call it.
Empty tel. number memories are skipped. If all memories are empty, the dialer is completely disabled.
To delete a telephone number enter:
7 F0 Fy
where y is a memory number from 1 to 4
entering 7 F0 F0 will erase all tel. numbers, including the Pager number
Alarm system JA-60 "COMFORT"
hh = hours (24 hr. cycle)
mm = minutes
dd = day
MM = month
RR = year
5 nSC nSC
where nSC is your new Service Code (four digits)
where = telephone number
xx...xx
= memory number from 1 to 4
y
-
15 -
sequence: 4 hh mm dd MM YY
sequence: 5 nSC nSC
sequence: 7xxx....xxFy
(pause can not be entered as the first
MDY51306