Closing The Cover - IBM eServer 445 xSeries Hardware Maintenance Manual And Troubleshooting Manual

Closing the cover

Complete the following steps to install the server cover:
1. Close the cover by first closing the right side; then, close the left side and press
Figure 74. Closing the cover
2. Reconnect all external cables and power cords to the server; then, plug the
3. Slide the server into the rack enclosure until it stops; then, secure the server in
4. Turn on the server.
down to latch the two halves of the cover in place.
power cords into properly grounded electrical outlets. See Chapter 5, "I/O
connectors and indicators," on page 145 for connector locations.
the rack enclosure using the quick release latches.
Chapter 4. Installing options
125