Media Bay Card - IBM eServer 445 xSeries Hardware Maintenance Manual And Troubleshooting Manual

Media bay card

Complete the following steps to remove the media bay card.
Note:
1. Turn off the server (see "Turning off the server" on page 10) and disconnect all
2. Open the cover (see "Opening the cover" on page 82).
3. Remove the DASD backplane (see "DASD backplane" on page 175).
4. Insert your fingers in the two thumb holes and push toward the outside edges of
5. Pull the card out of the server.
6. To replace the media bay card, reverse the previous steps.
176
xSeries 445 Type 8870: Hardware Maintenance Manual and Troubleshooting Guide
v Read "Installation guidelines" on page 79.
v Read the safety notices at "Safety notices (multilingual translations)" on
page 260.
v Read "Handling static-sensitive devices" on page 80.
power cords and external cables.
Note: The illustrations in this document might differ slightly from the hardware
being serviced.
the card until the card is released.
Finger holes
Latches