Installing The Serial Port - IBM eServer 445 xSeries Hardware Maintenance Manual And Troubleshooting Manual

Figure 38. Connecting the SCSI cable to the SCSI backplane
10. Close the cover on the server; then, reinstall the server in the rack and
11. Turn on the server.

Installing the serial port

Included with the server is a serial port that you can install at any time. This section
provides the instructions for installing the serial port.
Note: The serial port will occupy PCI-X slot one.
Complete the following steps to install the serial port.
Front of server
SCSI backplane
connector
8. Reinstall fans 3 and 4.
9. If you have other options to install or remove, do so now.
connect all external cables.
1. Review the information in "Safety information" on page 257 and "Installation
guidelines" on page 79.
2. Pull out on the quick release latches on each side of the server; then, pull the
server out of its rack enclosure until it stops.
3. Open the top cover.
Chapter 4. Installing options
91