Remote Supervisor Adapter Connectors And Leds - IBM eServer 445 xSeries Hardware Maintenance Manual And Troubleshooting Manual

v Video port: Connect the signal cable for a monitor to this port.
v Power LED: This green LED comes on and stays on when you plug in the

Remote Supervisor Adapter connectors and LEDs

This group of connectors and LEDs on the back of the server are used for
system-management information and control.
External power
connector
Figure 101. Remote Supervisor Adapter connectors and LEDs
v External power connector: You can connect an optional ac power adapter to
v Error LED: This amber LED is lit when a system-management error has
v ASM interconnect port: Connect signal cables for managing expansion-module
v Ethernet activity LED: This green LED is lit when there is activity on the
v Ethernet link LED: This green LED is lit when the Ethernet link is active.
v 10/100 Ethernet port: Connect Ethernet signal cables to this port.
v Management port: Connect a serial cable to this port to enable system
v Power LED: This green LED comes on and stays lit when you plug in the server.
Important: When the Remote Supervisor Adapter II-EXA is installed in place of
the Remote Supervisor Adapter, you must connect the monitor or
console switch to this video port. The integrated video controller on
the server is disabled for models with a Remote Supervisor Adapter
II-EXA installed.
server.
Error LED
(amber)
Power LED
(green)
this connector.
occurred.
resources to this port.
Ethernet LAN.
management through a modem, or connect a null modem cable to this port to
enable system management through a workstation or laptop computer.
Ethernet activity LED
(green)
ASM interconnect
port
Management port
Chapter 5. I/O connectors and indicators
Ethernet link LED
(green)
10/100
Ethernet port
149