Light Path Card - IBM eServer 445 xSeries Hardware Maintenance Manual And Troubleshooting Manual

Light path card

Complete the following steps to remove the light path card.
Note:
1. Turn off the server (see "Turning off the server" on page 10) and disconnect all
2. Remove the two front fans (see "Replacing and troubleshooting fans" on page
3. Remove the front bezel (see "Removing and replacing the bezel" on page 83).
4. Open the cover (see "Opening the cover" on page 82).
5. Disconnect the light path cable from the center plane (see "Center plane
6. From the front of the server, grasp the edge of the light path card, push it in
7. Inside the server, squeeze the Light Path card at the arrows to free it from the
8. Slide the card the rest of the way out of the server.
9. To replace the Light Path card, reverse the above steps.
v Read "Installation guidelines" on page 79.
v Read the safety notices at "Safety notices (multilingual translations)" on
page 260.
v Read "Handling static-sensitive devices" on page 80.
power cords and external cables.
122).
connectors, jumpers and LEDs" on page 159).
slightly to release the catch mechanism, and then pull it out until it tilts
downward.
Note: The illustrations in this document might differ slightly from the hardware
being serviced.
server.
Chapter 6. FRU information (service only)
185