IBM eServer 445 xSeries Hardware Maintenance Manual And Troubleshooting Manual page 60

10. Use the arrow keys to select Exit Utility from the menu or press Esc to close
11. Remove the diskette from the server. The server restarts automatically.
12. If you also want to configure the management port, continue with "Configuring
Configuring the management port for text-based remote access: Complete the
following steps to configure the Remote Supervisor Adapter management port for
access using a modem or null modem. If you completed the procedure for
configuring the Ethernet port and the Configuration Settings window is open, go to
step 3
Figure 24. Ethernet Settings window with text-based remote access values
50
xSeries 445 Type 8870: Hardware Maintenance Manual and Troubleshooting Guide
7. Press Esc. After the Warning window opens, press Enter to restart the Remote
Supervisor Adapter.
8. Press Esc to return to the Configuration Settings window.
If you need to configure the management port, go to "Configuring the
management port for text-based remote access."
9. Press Esc to return to the Utility program main window.
the Utility program.
the management port for text-based remote access." Otherwise, go to
"Installing Advanced System Management device drivers" on page 53.
1. With the server turned off, insert the diskette with the downloaded utility
program into the diskette drive; then, turn on the server. The utility starts
automatically, displaying the Remote Supervisor Utility window.
2. Use the Up Arrow and Down Arrow keys (↑ and ↓) to select Configuration
Settings; then, press Enter.
The Configuration Settings window opens.
3. Use the arrow keys to select Modem Settings; then, press Enter.
The Modem Settings window opens, as shown in the following illustration.
Note: The values in the window are only examples; your settings might be
different.