Closing the cover
Close the cover by first closing the right side; then, close the left side and press
down to latch the two halves of the cover in place.
Installing the server in a rack
Detailed cabling instructions, including the use of the cable management arm
(which comes with the server) are in the Rack Installation Instructions provided with
the server.
Connecting the cables
Notes:
1. You must turn off the server before connecting any cables to or disconnecting
2. See the documentation that comes with your external options for additional
3. If you have just plugged the power cords of the server into an electrical outlet,
The following illustration shows the locations of the input and output connectors on
your server. See Chapter 3, "Input/output connectors", on page 41 for descriptions
any cables from the server.
cabling instructions. It might be easier for you to route any cables before you
connect the devices to the server.
you must wait 30 seconds before pressing the power-control button.
Chapter 2. Installing options
37