IBM eServer 445 xSeries Hardware Maintenance Manual And Troubleshooting Manual page 181

3) Release the PCI-X assembly ( 1 ) from the I/O board ( 2 ) by sliding
( 3 ) the PCI-X assembly toward the rear of the server so that the five
tabs ( 4 ) in the I/O board are released from the five notches ( 5 ) in
the PCI-X assembly.
4) Lift the PCI-X assembly off of the I/O board and set it on a safe, clean
work surface.
Note: The illustrations in this document might differ slightly from the
hardware being serviced.
5) Remove the screws attaching the Remote Supervisor Adapter to the I/O
board:
Remote Supervisor
Adapter II-EXA
I/O Board
Figure 113. Remote Supervisor Adapter II-EXA model
a) On models with the Remote Supervisor Adapter II-EXA, use a nut
driver to remove the video port screws.
Riser
Card
Screws from
video Port
SCSI Cable
Chapter 6. FRU information (service only)
171