Oracle Sun SPARC Enterprise M3000 Reference Manual page 258

setnetwork(8)
244 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised April 2010
After you set the network interface, if you disable that network interface and
■
execute the applynetwork(8) command, the setting data of IP address and
netmask will be stored in XSCF. When you enable the network interface, the
setting of IP address and netmask will be used.
In the following cases, the setnetwork(8) command results in an error:
■
When specified the same IP address as an existing IP address
■
When specified a subnet which is the same with DSCP
■
When specified the same subnets in ISN and in other network interface
■
When specified the -c or -r option and ISN together
■
When the netmask that specified by using the -m addr option does not
■
correspond to either of the cases below:
Only the most significant bit is 1
Repeated 1 from the most significant bit
If M3000/M4000/M5000 servers corresponds to the cases below, the
■
applynetwork(8) command results in an error.
If xscf#0-lan#0 and xscf#0-lan#1 are in the down status
■
If xscf#0-lan#0 and xscf#0-lan#1 are in the up status and the same subnets
■
have been set
On M8000/M9000 servers, if xscf#0-lan#0, xscf#1-lan#0, xscf#0-lan#1, and xscf#1-
■
lan#1 are all in the down status, the applynetwork(8) command results in an
error.
On M8000/M9000 servers, if the network interface which is in the up status has
■
the following settings, the applynetwork(8) command results in an error.
If the subnet of xscf#0-lan#0, xscf#1-lan#0, and the takeover IP address lan#0
■
are different
If the subnet of xscf#0-lan#1, xscf#1-lan#1, and the takeover IP address lan#1
■
are different
If the subnet of ISN is different
■
If the subnet of xscf#0-lan#0 and xscf#0-lan#1 are the same
■
If the subnet of xscf#1-lan#0 and xscf#1-lan#1 are the same
■
In case you specified the IP address and the netmask to the interfaces other than
■
ISN and when the ISN is not configured, the following default value will be set:
xscf#0-if:
■
IP address: 192.168.1.1 Netmask: 255.255.255.0
xscf#1-if:
■
IP address: 192.168.1.2 Netmask: 255.255.255.0
The shownetwork(8) command can display current information on a network
■
interface configured for XSCF.