Oracle Sun SPARC Enterprise M3000 Reference Manual page 23

When the command is executed, a prompt to confirm execution of the command
■
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
If "-c configure" is specified when either the domain power has been turned
■
off or the Solaris OS is not running, an error occurs.
When "-c configure" is specified, hardware diagnosis is performed on the XSB
■
before it is incorporated into the domain. Therefore, command execution may
take time.
To use the addboard(8) command to configure or assign an XSB, DCL must be
■
set up in advance using the setdcl(8) command.
If the addboard(8) command is executed under the progress of power-on or
■
power-off processing, the busy status is returned. After that processing in the
domain is completed, reexecute the command.
See the setdcl(8) and showdcl(8) commands for DCL.
■
EXAMPLES
EXAMPLE 1
XSCF>
EXAMPLE 2
XSCF>
The following exit values are returned:
EXIT STATUS
0
>0
SEE ALSO deleteboard(8), moveboard(8), replacefru(8), setdcl(8), setdomainmode(8),
setupfru(8), showboards(8),showdcl(8), showdevices(8),
showdomainstatus(8), showfru(8), testsb(8)
Configures XSB#00-0, #01-0, #02-0, and #03-0 into domain ID 0.
addboard -y -c assign -d 0 00-0 01-0 02-0 03-0
Configures XSB#00-0, #01-0, #02-0, and #03-0 forcibly into domain ID 2.
addboard -f -d 2 00-0 01-0 02-0 03-0
Successful completion.
An error occurred.
addboard(8)
System Administration 11