Denwa Communications DW-610G User Manual page 59

separated by commas, or a list of digits.
If user makes the above configuration, after user dials 11 digit numbers started with
from 132 to 139, the phone will send out 0 plus the dialed numbers automatically.
Use this phone you can realize dialing out via different lines without switch in web
interface.
Field name
Phone number
Destination
Port
Alias
Note: There are four types of aliases.
DIAL PEER
explanation
There are two types of matching conditions: one is full
matching, the other is prefix matching. In the Full
matching, you need input your desired phone number in
this blank, and then you need dial the phone number to
realize calling to what the phone number is mapped. In
the prefix matching, you need input your desired prefix
number and T; then dial the prefix and a phone number to
realize calling to what your prefix number is mapped. The
prefix number supports at most 30 digits.
Set Destination address. This is optional config item. If
you want to set peer to peer call, please input destination
IP address or domain name. If you want to use this dial
rule on SIP2 line, you need input 255.255.255.255 or
0.0.0.2 in it.SIP3 into 0.0.0.3
Set the Signal port, the default is 5060 for SIP.
Set alias. This is optional config item. If you don't set
Alias, it will show no alias.