Frame Pattern Print (Function Code 69) - Brother MFC-9320CW Service Manual

1.4.20 Frame pattern print (Function code 69)

<Function>
This function allows you to print the external periphery frame pattern on a sheet and check if
there is print deflection and/or loss.
<Operating procedure>
(1) Load Letter-size paper on the paper tray.
(2) Press the 6 and 9 buttons in this order in the initial state of the maintenance mode.
"PRINTING" is displayed on the LCD, and the frame pattern (see the figure below) is
printed on a sheet.
Note:
When printing fails, a relevant error is displayed on the LCD. After the error is solved and
the Start/Black button is pressed, the machine automatically goes back to the
re-executable state, and "WAKU SX" is displayed on the LCD. When the OK button is
pressed, "PRINTING" is displayed on the LCD, and the frame pattern is printed on a sheet.
(3) When the Stop/Exit button is pressed, the machine beeps for one second and returns to
the initial state of the maintenance mode
When an error message is displayed on the LCD, take the measures described in the table below.
Error message
TONER EMPTY # *
Cover is Open
No Paper
Jam Tray1
Jam Rear
* # indicates the toner color (K, Y, M, or C) of which cartridge became empty.
Replace the empty toner cartridge and press the Start/Black
button to clear the error. Perform the frame pattern print
again.
Close the top cover.
Replenish paper, and press the Start/Black button to clear
the error.
Remove the jammed paper, and press the Start/Black
button to clear the error.
Remove the jammed paper, and press the Start/Black
button to clear the error.
7-38
Measure
Confidential