Print Frame Pattern (Single-Side Printing) (Function Code: 69) - Brother DCP-7080 Service Manual

1.3.20 Print frame pattern (single-side printing) (function code: 69)

<Function>
This function is used to print the frame pattern on a single side of the paper to check for
printing flaws and omission.
<Operating Procedure>
For models without keypad
(1) Set the paper specified in the default
paper settings (A4 or Letter) to the paper
tray.
(2) Press the [▲] or [▼] key in the initial
state of maintenance mode to display
"MAINTENANCE 69" on the LCD, and
press the [OK] key. "PRINTING" is
displayed on the LCD, and the frame
pattern (refer to the figure below) is
printed on a single side of the paper.
(3) When printing is completed, "WAKU SX"
is displayed on the LCD.
(4) When the [Stop] key is pressed, the
machine stops this operation and
returns to the initial state of maintenance
mode.
Note:
• If printing fails, printing is stopped with displaying any of the errors shown in the table
below. To retry printing, refer to the "Remedy" in the table below to eliminate the error
cause, and press the [Start] or [Mono Start] key. "PRINTING" is displayed on the LCD,
and the frame pattern is printed on a single sheet of the paper.
Error display
Replace Toner
Cover is Open
No Paper
Jam Tray1
Jam Rear

Frame pattern
For models with keypad
(1) Set the paper specified in the default
(2) Press the [6], and then the [9] key in the
(3) When printing is completed, "WAKU SX"
(4) When the [X] or [Stop] key is pressed,
Replace the empty toner cartridge and press the [Start] key to
release the error.
Close the front cover.
Refill the paper tray and close it. And then press the [Start] key to
release the error.
Remove the jammed paper, close the paper tray and all covers,
and press the [Start] key to release the error.
Fig. 5-16
5-34
paper settings (A4 or Letter) to the paper
tray.
initial state of maintenance mode.
"PRINTING" is displayed on the LCD,
and the frame pattern (refer to the figure
below) is printed on a single paper.
is displayed on the LCD.
the machine stops this operation and
returns to the initial state of maintenance
mode.
Remedy
Confidential