If You Replace The Wireless Lan Pcb (Wireless Lan Model Only); Acquiring Mac Address (Ethernet Address) From Main Pcb; If You Replace The Registration Sensor Holder Assy; Sensitivity Adjustment Of Density Sensor (Maintenance Mode: Code 72) - Brother MFC-9320CW Service Manual

2. IF YOU REPLACE THE WIRELESS LAN
PCB (WIRELESS LAN MODEL ONLY)
■ What to do when replacing the wireless LAN PCB

Acquiring MAC Address (Ethernet Address) from Main PCB

2.1 Acquiring MAC Address (Ethernet Address) from Main PCB
<Procedures>
(1) Turn ON the power as holding down the
Keep holding down the
(2) When the MAC address (Ethernet address) is acquired from the main PCB, "W Lan
Module OK" is displayed on the LCD.
(3) Turn OFF the power.
3. IF YOU REPLACE THE REGISTRATION
SENSOR HOLDER ASSY
■ What to do when replacing the registration sensor holder ASSY

Sensitivity Adjustment of Density Sensor (Maintenance Mode: Code 72)

3.1 Sensitivity Adjustment of Density Sensor
(Maintenance Mode: Code 72)
Make adjustments of the density sensor in accordance with
density sensor" in Chapter 7.
4. IF YOU REPLACE THE DOCUMENT
SCANNER UNIT
■ What to do when replacing the document scanner unit
Acquisition of the white level data and setting of the CIS scanner area
4.1

Acquiring White Level Data and Setting CIS Scanner Area

<Procedure>
(1) Press the Menu button and Start/Black button in this order, and then press the
four times to go into the maintenance mode. (Refer to
Mode" in Chapter
(2) Press the 5 button twice.
(3) Press the Start/Black button. The white level data is automatically acquired.
(4) When the acquisition is completed, the machine automatically returns to the initial state of
the maintenance mode.
button and OK button until "Check start" appears.
7.)
6-13
button and OK button at the same time.
"1.4.22 Sensitivity adjustment of
"1.1 How to Enter Maintenance
button
Confidential