Pull Arm L/Pull Arm R/Pull Arm Spring - Brother MFC-9320CW Service Manual

8.11 Pull Arm L/Pull Arm R/Pull Arm Spring

(1) Remove the Taptite cup S M3x6 SR screw, and then remove the CIS harness hold plate.
Taptite cup S M3x6 SR
CIS harness hold plate
<Left side>
(2) Disconnect the CIS harness from the Main PCB ASSY.
Note:
- After disconnecting the flat cable(s), check that each cable is not damaged at its end
or short-circuited.
- When connecting the flat cable(s), do not insert it at an angle. After insertion, check
that the cable is not at an angle.
Document scanner unit
Main PCB ASSY
Main PCB harness film 1
CIS harness
<Left side>
Hook
Hook
Fig. 5-32
CN20
Fig. 5-33
5-54
Main shield cover
plate ASSY
Confidential