Registration Front/Rear Sensor Pcb Assy - Brother MFC-9320CW Service Manual

8.64 Registration Front/Rear Sensor PCB ASSY

(1) Remove the two Taptite cup B M3x10 screws from the PF upper cover ASSY.
(2) Keep the shutter part of the Registration rear actuator at the position shown in the figure below.
(3) Release the two Bosses to remove the PF upper cover ASSY from the Paper feed unit.
Note:
When removing the PF upper cover ASSY, be careful not to damage the Registration
rear actuator.
Taptite cup B M3x10
Boss
(4) Disconnect the Connector (CN2) of the Manual sensor harness ASSY from the
Registration front/rear sensor PCB ASSY.
Paper feed unit
PF upper cover ASSY
Fig. 5-186
Fig. 5-187
Taptite cup B M3x10
PF upper cover ASSY
Boss
Paper feed unit
Registration front/rear sensor PCB ASSY
5-150
Registration rear
actuator
Shutter part
CN2
Manual sensor
harness ASSY
Confidential