Rear Projection; Ceiling Mode; Lens Control; Lens To Midposition - Barco RLM-W14 User Manual

11.Alignment
Rear projection - ceiling mode
Press MENU  Advanced ALIGNMENT  Rear Projection and choose ON;
press MENU once more  Advanced ALIGNMENT  Ceiling Mode and choose ON
Correct Picture
canoe



11.3 Rear Projection

The default of the Rear Projection setting is Off.
See 11.2 Adjusting screen orientation, refer to page 55: 11.2 Adjusting screen orientation

11.4 Ceiling Mode

The default setting is Off.
Whenyou have set up the projector for ceilingmode (hung from the ceiling in reverse), please set it to ON. Refer to page 55:
11.2 Adjusting screen orientation

11.5 Lens Control

Zoom
Use this function to zoom in or zoom out the image size. Refer to page 17: Lens zoom.
Focus
Use this function to adjust the image Focus. Refer to page 16: Lens focus
Shift
Use this function to adjust the lens shift. Refer to page 17: Lens Shift.

11.6 Lens To Midposition

After series of lens shift operations, this function can be used to return the lens to the center position.

11.7 Lens Calibration

Lens calibration should be performed every time a lens was installed at the projector. The process will determine the
minimum and maximum ranges of the zoom and focus for the lens installed. With this calibrated information, zoom and
focus will be adjusted within the safe ranges. The workflow is defined as the following:
Install a lens on the projector
Go to the advanced menu and Perform "Lens Calibration" function
Wait for the lens calibration process completed
Please do not press any key during Lens Calibration. Press "Enter" to stop Lens Calibration process.
L
56
RLM W14 08/20/2014