Auto Image - Barco RLM-W14 User Manual

H Start
Use to adjust the projected image's horizontal position.
If the projected image is not at the center of the screen (i.e. shifted to right or left) and ends up being cropped, use this
function to adjust the image's horizontal position.The following image is an example of test image from an external signal
source:
Native picture
V Phase
Use  to adjust the projected image's phase.
Use this function to adjust the phase of pixel sampling clock (relative to input signal). Should the image still flicker or show
noise (i.e. edges on texts) after optimization, adjust phase accordingly.
Phase only available with analog data sources
V Start
Use  to adjust the projected image's vertical position.
If the projected image is not at the center of the screen (i.e. shifted up or down) and ends up being cropped, use this function
to adjust the image's vertical position.The following image is an example of test image from an external signal source:
原始圖面
Native picture
It is recommended that when adjusting the image, the horizontal total should be adjusted before the
horizontal phase. However, if the image still flickers even after you have adjusted both, try lowering the
image noise.

8.10 Auto Image

When Auto Image was selected in the Advanced menu, press
By executing this function, the projector will resync the image. Use this function when the image source is unstable or when
you notice deterioration in image quality and the projector will automatically adjust the image size, phase and timing. (The
adjustment also applies to PIP input source).
RLM W14 08/20/2014
Skewed left
圖面下偏
Skewed down
OK
to execute the automatic image adjustment function.
Skewed right
圖面上偏
Skewed Up
8.Image
47