Menu Position; Start Up Logo; Start Up Chime; Button 1 - Barco RLM-W14 User Manual

12.5 Menu Position

You can use this function to designate which area on the image the OSD Menu will appear.
As you can see from the diagram below, there are five positions where you can choose to have the OSD Menu displayed.The
default setting is "Center".

12.6 Start Up Logo

You can use this function to have the projector display the Barco logo in the start up screen. Set
Off
during start up and

12.7 Start Up Chime

Set it to On to have the projector play a sound effect during start up; when it is set to off, the projector will not play any
sound effect to indicate start up.

12.8 Button 1 ~ 5

These buttons on the remote control are the hotkeys for different image source. By factory default, these are:
1 = HDMI
2 = HDBaseT
3 = VGA
4 = RGBHV/YUV2
5 = Stereo DVI
You can configure the input source that corresponds to each button in the OSD Menu. To do so:
MENU
When press > CONTROL > Button 1~5; use the
from: HDMI 1,HDMI 2,RGB D-15,YUV 1,RGBHV/YUV 2,Composite Video,S-Video and RGB-S.
For example, if you have configured
projector will display the image from RGB D-15.
RLM W14 08/20/2014
Top Left
Bottom Left
to display a blank image.
1 as RGB D-15 in the OSD Menu, when you press
Top Right
Center
Bottom Right
▼ ▲
buttons to choose from diffferent sources of input. You can choose
On
to display the Barco logo
1
on the remote control, the
12.Control
67