Barco RLM-W14 User Manual page 70

11.Alignment
Image 1 Image 1
Reset
The function can reset the ScenergiX settings on the projector. It will restore to the images to the default that is without any
ScenergiX functions enabled.
Adjust Lines
When the function is ON, there will be adjust lines on the image in order to easily adjust multiple images. Press  on
the remote control to adjust the position of the lines on the image.
The image below is an example if 2 projectors are projecting at the same image.
1. Horizontally place two projectors and have the two projected images with an overlap area and use the focus/zoom
and lens shift functions with test grid pattern to set a proper overlap area for blending with a matched grid size.
2. Color matching 2 projectors on white is done with P7 (R.G.B.C.M.Y.W) adjust in projector toolset.
3. Brightness matching 2 projectors can be done with the lamp power(Refer to adjustment by dimming the projector with
higher lumens.
4. Use ScenergiX-> White level to set the blending size based on the overlap region size.
Use ScenergiX-> Black level position to adjust the start position of black level compensation.
Use ScenergiX-> Black level to raise the brightness of non-overlap zone such that the brightness of the overlap zone and
non-overlap zone are matched for black level.
62
A A B B
White Level Lines White Level Lines
D D
for black level adjustment a black image needs to be
C C
connected on the 2 projectors. Zone B will have the sum of the
blacks of the 2 projectors. Set the adjustment line of the black
level to the position where the non active DMD's of the right
projector ends. Set the adjustment line of the black level to
the position where the non active DMD's of the left projector
ends. Adjust black level of projector A to match the black level
with zone B. Adjust the projector C to match the black level
with zone B.
Image 2 Image 2

Blend along
corners
RLM W14 08/20/2014