Barco RLM-W14 User Manual page 80

14.Lamp and Filter Maintenance
4. Grasp the metal rod on the lamp cover and pull the lamp out.
5. Insert the new lamp in the direction shown in the illustration into the lamp assembly; tighten the two screws using a
screw diver and make sure the lamp is firmly secured to prevent the lamp from shaking or poor contact.
6. Replace the lamp cover and firmly secure the two screws on the lamp cover.
7. Reconnect power to the projector and reset the lamp usage timer. Refer to
53: 10.9 Lamp2 Run Time
While starting up the projector, the electronics detect if a lamp is installed. If no lamp is installed, it is not
possible to start up the projector.
72
page 53: 10.8 Lamp1 Run Time and page
RLM W14 08/20/2014