Barco RLM-W14 User Manual page 38

4. Input & Communication
10/100 BASE-T
Connects the projector to your PC via network to have direct control of the projector from the PC.
Stereo DVI
Connect the Stereo DVI to a stereo 3D source - it is usually a computer with 3D Graphics card and 3D applications.
3D mode
There are few ways to go to the 3D mode
- OSD menu: Go to Main Menu "Input > Input Selection", and select STEREO DVI
- Remote control: Press hot key "5" to go to STEREO DVI directly (factory default, not suitable for user-defined shortcuts )
- Network Webpage: Go to "Source/general" > "Source" and select STEREO DVI
- RS232 Commands : Use " Input.sel = 1-8" to select any other source that is available.
There is no osd available when using the stereo dvi input. The projector needs to be controlled by projector
toolset web browser.
2D mode
Please note that OSD menu is not available in 3D mode. The ways to switch back to 2D mode are:
- Remote control: Press any of the input key 1-4 will switch back to 2D mode.
(factory default, not suitable for user-defined shortcuts )
- Network Webpage: Go to "Source/general" > "Source" and select any other source that are available.
- RS232 Commands: Use " Input.sel = 1-8" to select any other source that are available.
30
IR Emitter
200mA
L / R Sync signal
3D Glasses
EMITTER L/R signals
LAN
Desk Top
or Notebook
RLM W14 08/20/2014