Getting Started; How Controlling The Projector; Remote Control Functions; Rcu & Local Keypad - Barco RLM-W14 User Manual

5. Getting Started

5. GETTING STARTED
Overview
• RCU & Local keypad

• Power on projector

• Switching to standby
• Power off projector
• Range of effective remote control signal reception
• Source selection
• Changing OSD language
• Adjusting the lens by horizontal and vertical lens shift
5.1 RCU & Local keypad

How controlling the projector ?

The projector can be controlled by the local keypad or by the remote control unit.
Location of the local keypad ?
The local keypad is located on the input side of the projector.

Remote control functions.

This remote control includes a battery powered infrared (IR) transmitter that allows the user to control the projector remotely.
This remote control is used for source selection, control, adaptation and set up.
5.2 Power on projector
How to power on.
Press the power switch at the back of the projector to switch on this projector.
When the projector is turned off, it is required to wait for at least 90 seconds to re-start the projector to
complete the cooling of lamp.
Starting image projection via the standby key.
Press key once on the local keypad or
STBY
32
- When '0' is pressed, the projector is switched off.
- When '1' is pressed, the projector is switched on.
The projector starts up in standby.
The start up screen is displayed on the screen and when fully started up, it changes to the
overview screen.
on the remote control.
RLM W14 08/20/2014