Switching To Standby; Power Off Projector; Range Of Effective Remote Control Signal Reception - Barco RLM-W14 User Manual

5.3 Switching to standby

How to switch to standby
1. Press Power button on keypad or remote control for 3 seconds for projector to go into standby.
2. Wait until the projector completes the cooling process – at least 3~5 minutes.
3. Please do not press any key on the keypad or remote control before the projector goes into standby mode.
All custom settings are written to the internal backup device. A message 'Saving data ...' indicates
this process. Never switch off the projector while this message is displayed.
When switching to standby, an after cooling process will start to cool down the projector. The after cool
time depends on the temperature inside the projector and can vary from 30 second to 5 minutes.

5.4 Power off projector

How to power off
1. Press Power button on keypad or remote control for 3 seconds for projector to go into standby.
2. Wait until the projector completes the cooling process – at least 3~5 minutes.
3. Switch off the projector with the power switch to ' 0"
C
AUTION: Never switch off the projector while the message 'Saving data ... ' is displayed !

5.5 Range of effective remote control signal reception

The diagram below illustrates the range of effective remote control signal reception.
Avoid placing the remote control at places of high temperature or humidity as it could cause the remote
control to malfunction.
RLM W14 08/20/2014
40°
40°
5. Getting Started
33