Cisco Power system Installation Manual page 68

Connecting Routers and the Cisco MC3810 Concentrator
Connect the other end of the Cisco RPS AC power cable into a grounded AC
Step 5
power outlet.
Power up the Cisco RPS. There is one power switch for each of the AC input
Step 6
power modules. Make sure that the power switch for each connected AC cable is
in the ON (|) position. (See
Figure 4-25 Powering Up the Cisco RPS
Power switch
Power on the router or concentrator by pressing the power switch to the ON (|)
Step 7
position.
The Cisco RPS is on and provides power to the external device in 10 to 15 seconds.
The Cisco RPS is working properly when all its front-panel LEDs are solid green. If
the external device does not power up, see
Cisco RPS."
Cisco Redundant Power System Hardware Installation Guide
4-18
Chapter 4
Figure 4-25.)
Chapter 5, "Troubleshooting the
Connecting the Cisco RPS
OL-3654-01