Connecting Routers And The Cisco Mc3810 Concentrator - Cisco Power system Installation Manual

Chapter 4 Connecting the Cisco RPS
Connecting Routers and the Cisco MC3810
Concentrator
Note
Note
Step 1
Step 2
OL-3654-01
This section provides illustrations and cabling information for connecting the
Cisco RPS to Cisco 2500 series and Cisco 2600 series routers; Cisco 3620, Cisco
3640, and Cisco 3725 routers; Cisco 4000 series routers and Cisco MC3810
multiservice concentrators. All these devices use:
One-to-one cable for quasi-redundancy
•
or
Two-to-one Y-cable for full redundancy
•
If you did not order your router or concentrator with a Cisco RPS connector
installed, you must order a power adapter plate and must install it in place of your
existing power supply.
If you need to order a power adapter plate, see
adapter plates and corresponding product order numbers. Contact Cisco Customer
Service at 800 553-6387 or 408 526-7209 for ordering information. (See also the
"Obtaining Documentation" section on page
Device-specific instructions for installing the Cisco RPS adapter plate are shipped
with the plate and are also available on Cisco.com at http://www.cisco.com.
Cisco IOS Software Release 11.2(7)P or later release is required when using the
Cisco RPS with Cisco 3620, Cisco 3640, or Cisco 3725 routers.
To connect a router or multiservice concentrator to the Cisco RPS, perform the
following steps:
Power off the router or concentrator by pressing the power switch to the OFF (O)
position.
Connect one end of the one-to-one cable or Y-cable to the Cisco RPS connector
on the rear panel of the router or concentrator, as shown in
Figure 4-21.
Cisco Redundant Power System Hardware Installation Guide

Connecting Routers and the Cisco MC3810 Concentrator

Table 3-1 on page
xviii.)
3-5, which lists
Figure 4-16 through
4-13