Cisco Power system Installation Manual page 67

Chapter 4 Connecting the Cisco RPS
Connecting Routers and the Cisco MC3810 Concentrator
Figure 4-23 Connecting a Two-to-One Y-Cable for Fully Redundant Power
AC INPU T 1 DC OUT PUT 1
DC OUT PUT 2
AC INPU T 2
100- 200 V~ 50/6 0 Hz DC OUT PUT 3
DC OUT PUT 4
100- 200 V~ 50/6 0 Hz
10-5 A 1000 W
10-5 A 1000 W
On the rear panel of the Cisco RPS, connect an AC power cable to either or both
Step 4
of the power connectors. Use the cable locks on the Cisco RPS to lock the cables
in place. (See Figure 4-24.)
Figure 4-24 Connecting the AC Power Cables to the Cisco RPS
Cable locks
Cisco Redundant Power System Hardware Installation Guide
4-17
OL-3654-01