Supported Devices And Configurations - Cisco Power system Installation Manual

Supported Devices and Configurations

Note
Supported Devices and Configurations
Cisco Redundant Power System Hardware Installation Guide
1-2
LEDs for AC, DC, fans, and temperature status
•
Simple Network Management Protocol (SNMP) support of error messages
•
for Cisco 2600 series and Cisco 3620/3640 series routers. (There is no SNMP
support for error messages in the Cisco 1516M hub, FastHub 400 series hub,
Catalyst 1900 series switches, Catalyst 2820 series switches, Catalyst 2900
and Catalyst 3500 series XL switches, Cisco 2500 and 4000 series routers,
and the Cisco MC3810 multiservice concentrator.)
The Cisco RPS ships in either of the following configurations:
With cables (Cisco RPS number PWR600-AC-RPS-CAB)—Includes four
•
one-to-one (22-pin to 18-pin) cables for connecting to hubs and switches or
for quasi-redundant support for Cisco 2600 series routers; Cisco 3620, Cisco
3640, and Cisco 3725 routers; and Cisco 4000 series routers.
Without cables (Cisco RPS number PWR600-AC-RPS-NCAB)—Cables
•
must be ordered separately:
One-to-one (22-pin to 18-pin) cables for connecting to hubs and switches
–
or for quasi-redundant support for Cisco 2600 series routers; Cisco 3620,
Cisco 3640, and Cisco 3725 routers; and Cisco 4000 series routers
One-to-one (22-pin to 8-pin) cables for quasi-redundant support for
–
Cisco 2500 series routers and access servers and Cisco MC3810
multiservice concentrators
Two-to-one Y cables (22-pin to 18-pin or 22-pin to 8-pin) for fully
–
redundant support only for routers or concentrators
Refer to Table 3-1 on page 3-5
Table 1-1 lists the supported external devices and power configurations. The
power configurations are described in the following subsections.
for cable descriptions and order numbers.
Chapter 1 Overview
OL-3654-01