Cisco Power system Installation Manual page 60

Connecting Switches
Step 3
Figure 4-13 Connecting the One-to-One Cable to the Cisco RPS
AC INPU T 1
AC INPU T 2
100- 200 V~ 50/6 0 Hz
100- 200 V~ 50/6 0 Hz
10-5 A 1000 W
10-5 A 1000 W
Step 4
Cisco Redundant Power System Hardware Installation Guide
4-10
Connect the other end of the one-to-one cable to the Cisco RPS rear-panel
connector, as shown in
DC OUT PUT 1
On the Cisco RPS rear panel, connect an AC power cable to either or both of the
power connectors. Use the cable locks on the Cisco RPS to lock the cables in
place. (See Figure 4-14.)
Figure 4-13.
DC OUT PUT 2
DC OUT PUT 3
Chapter 4 Connecting the Cisco RPS
DC OUT PUT 4
OL-3654-01