Cisco Power system Installation Manual page 25

Chapter 1 Overview
.
Table 1-1 Cisco RPS-Supported External Devices and Power Configurations
External Device
FastHub 400 series hubs
Cisco 1516M hub (HP 10BASE-T Hub-16M)
Catalyst 1900 series switches
Catalyst 2820 series switches
Catalyst 2900 series XL switches
Catalyst 3500 series XL switches
Cisco 2500 series routers and access servers
Cisco 2600 series routers
Cisco 3620 and Cisco 3640 routers
Cisco 3725 routers
Cisco MC3810 multiservice concentrators
Cisco 4000 series routers
1. The Cisco RPS has a demonstrated mean time between failures (MTBF) of greater than 500,000 hours in this mode.
2. The redundant-with-reboot configuration is not recommended because of the reboot and downtime; if you use this
configuration, always power up the switch before you power up the Cisco RPS to ensure correct operation.
3. The Cisco RPS can also be used with the older FastHub 100, 200, and 300 series hubs.
4. If you are using a Cisco RPS with a revision level lower than Z3 with a Catalyst 3508G or a Catalyst 3548 XL switch, the
switch RPS LED and the RPS DC LED might display amber (normally indicating RPS malfunction) even when the Cisco RPS
is functioning properly. The LEDs display correctly for Cisco RPS revision level Z3 or later revision. The label on the bottom
of the Cisco RPS shows the revision level.
5. For simplicity, Cisco 2500 series access servers, such as the Cisco 2509 or the Cisco 2511, are referred to as Cisco 2500 series
routers throughout this guide.
Note
OL-3654-01
3
4
You might need to order a power adapter plate for your router or concentrator to
make it compatible with the Cisco RPS.
and order numbers.
Cisco Redundant Power System Hardware Installation Guide
Quasi-
1
Redundant
Yes
Yes
Yes
Yes
Yes
Yes
5
Yes
Yes
Yes
Yes
Yes
Yes
Table 3-1 on page 3-6
Supported Devices and Configurations
Fully Redundant with
Redundant Reboot
No Yes
No No
No Yes
No Yes
No Yes
No Yes
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
lists adapter plates
2
1-3