Safety Recommendations - Cisco Power system Installation Manual

Chapter 1 Overview
Table 1-2 LED Descriptions (continued)
LED Name Color/State
Amber
Green
FAN Off
Amber
Green
TEMP Off
Amber
Green

Safety Recommendations

OL-3654-01
Description
The DC output power module has failed.
The DC status LED is amber for 10 to 15 seconds after the DC
Note
output power module has been connected and the external device
has been powered up before it turns green to indicate correct
operation.
If you are using a Cisco RPS with a revision level lower than Z3
Note
with a Catalyst 3508G or a Catalyst 3548 XL switch, the switch
RPS LED and the RPS DC LED of the connector for the switch
might display amber (normally indicating a Cisco RPS
malfunction) even when the Cisco RPS is functioning properly.
The LEDs display correctly for Cisco RPS revision level Z3 or
later revision. The label on the bottom of the Cisco RPS shows
the revision.
The DC output power module is on and operating correctly.
AC power is not being supplied to the Cisco RPS.
One or more cooling fans has failed.
All cooling fans are functioning correctly.
AC power is not being supplied to the Cisco RPS.
The Cisco RPS internal temperature is exceeding the operating range.
The Cisco RPS internal temperature is within the operating range.
Follow these guidelines to guarantee general safety:
Keep the chassis area clear and dust-free during and after installation.
•
Keep tools and chassis components away from walk areas where you or others
•
could fall over them.
Do not wear loose clothing that could get caught in the chassis. Fasten your
•
tie or scarf and roll up your sleeves.
Cisco Redundant Power System Hardware Installation Guide
Safety Recommendations
1-11