Setting The Cisco Rps On A Desktop; Rack-Mounting The Cisco Rps - Cisco Power system Installation Manual

Chapter 2 Installing the Cisco RPS

Setting the Cisco RPS on a Desktop

Warning
Warning
Step 1
Step 2
Step 3
Step 4
Note

Rack-Mounting the Cisco RPS

OL-3654-01
Do not stack the chassis on any other equipment. If the chassis falls, it can
cause severe bodily injury and equipment damage. To see translations of the
warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information document that accompanied this device.
This unit is intended for installation in restricted access areas. A restricted
access area is where access can only be gained by service personnel through
the use of a special tool, lock and key, or other means of security and is
controlled by the authority responsible for the location. To see translations of
the warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information document that accompanied this device.
To install your chassis on a desktop, perform the following steps:
Unpack the Cisco RPS.
Attach the rubber feet from the accessory kit in the round recesses on the chassis
bottom.
Set the Cisco RPS chassis on an appropriate desktop.
Plug in the Cisco RPS, and turn power on.
If you have questions or need assistance, see the
section on page xviii.
This sections explains how to rack-mount the Cisco RPS in 19-, 23-, 24-inch, or
telco equipment racks. Read the following information before rack-mounting
your chassis.
Cisco Redundant Power System Hardware Installation Guide
Setting the Cisco RPS on a Desktop
"Obtaining Documentation"
2-3