Cisco Power system Installation Manual page 55

Chapter 4 Connecting the Cisco RPS
Figure 4-4
Step 5 Connect the other end of the Cisco RPS AC power cable into an AC power outlet.
If you are using the redundant-with-reboot configuration (not recommended),
Step 6
power up the switch by connecting the hub AC power cord to an AC power outlet.
Note
Power up the Cisco RPS. There is one power switch for each AC input power
Step 7
module. Make sure that the power switch is in the ON (|) position for each AC
power module used. (See
OL-3654-01
Connecting the AC Power Cables to the Cisco RPS
Cable locks
If you use the redundant-with-reboot configuration, always power up the
hub before you power up the Cisco RPS.
Figure
Cisco Redundant Power System Hardware Installation Guide
4-5.)
Connecting Hubs
4-5