Chapter 2 Installing The Cisco Rps - Cisco Power system Installation Manual

Installing the Cisco RPS
You can set the Cisco RPS chassis on a desktop or install it in a rack.
Only trained and qualified personnel should be allowed to install or replace
Warning
this equipment. To see translations of the warnings that appear in this
publication, refer to the Regulatory Compliance and Safety Information
document that accompanied this device.
Do not work on the system or connect or disconnect cables during periods of
Warning
lightning activity. To see translations of the warnings that appear in this
publication, refer to the Regulatory Compliance and Safety Information
document that accompanied this device.
Before opening the chassis, disconnect the telephone-network cables to
Warning
avoid contact with telephone-network voltages. To see translations of the
warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information document that accompanied this device.
This equipment is intended to be grounded. Ensure that the host is connected to
Warning
earth ground during normal use. To see translations of the warnings that appear
in this publication, refer to the Regulatory Compliance and Safety Information
document that accompanied this device.
OL-3654-01
C H A P T E R
Cisco Redundant Power System Hardware Installation Guide
2
2-1