Cisco Power system Installation Manual page 35

Chapter 1 Overview
This product relies on the building's installation for short-circuit (overcurrent)
Warning
protection. Make sure that a fuse or circuit breaker is no larger than 120 VAC,
15A U.S. (240 VAC, 10A international) is used on the phase conductors (all
current-carrying conductors). To see translations of the warnings that appear in
this publication, refer to the Regulatory Compliance and Safety Information
document that accompanied this device.
Warning This equipment is intended to be grounded. Make sure that the host is
connected to earth ground during normal use. To see translations of the
warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information document that accompanied this device.
Warning Ultimate disposal of this product should be handled according to all national
laws and regulations. To see translations of the warnings that appear in this
publication, refer to the Regulatory Compliance and Safety Information
document that accompanied this device.
Follow these guidelines when working on equipment powered by electricity:
•
•
•
OL-3654-01
Locate the emergency power-off switch in the room in which you are
working. Then, if an electrical accident occurs, you can quickly shut the
power off.
Look carefully for possible hazards in your work area, such as moist floors,
ungrounded power extension cables, and missing safety grounds.
If an electrical accident occurs, proceed as follows:
Use caution; do not become a victim yourself.
–
Turn off power to the Cisco RPS.
–
If possible, send another person to get medical aid. Otherwise, determine
–
the condition of the victim and then call for help.
Determine if the person needs rescue breathing or external cardiac
–
compressions; then take appropriate action.
Cisco Redundant Power System Hardware Installation Guide
Safety Recommendations
1-13