Removing The Motherboard - Mitsubishi Electric Apricot LS700 Owner's Handbook Manual

Installing the Power Supply

Removing the Motherboard

W W A A R R N N I I N N G G
This procedure should be done only by qualified technical
personnel. Observe the precautions in 'Before You Begin'.
1. Place the power supply in the chassis.
2. Insert and tighten the four screws that secure the power
supply to the chassis.
3. Connect the power cable to the motherboard.
4. Connect power cables to any peripheral devices.
W W A A R R N N I I N N G G
This procedure should be done only by qualified technical
personnel. Observe the precautions in 'Before You Begin'.
1. Switch off the computer and unplug the power cable.
2. Remove the top and access cover.
3. Label and disconnect all internal cables connected to
any add-in cards.
4. Remove all add-in cards.
5. Label and disconnect all internal cables attached to the
motherboard. Make note of wire colours and positions
for later installation.
6. Remove the power supply.
7. Remove the screws holding the motherboard to the
chassis. Retain them all for refitting.
8. Lift the motherboard out of the chassis, being careful
not to flex the board.
C h a s s i s a n d c o m p o n e n t s
LS700 HANDBOOK 2/27