Before Installing Options - Mitsubishi Electric Apricot LS700 Owner's Handbook Manual

S y s t e m d e s c r i p t i o n a n d i n s t a l l a t i o n
Power Supply Output
Before Installing Optional Items
1/6 LS700 HANDBOOK
DC Voltage
+12 V
+5 V
+5V Standby
+3.3 V
-5 V
-12 V
N N O O T T E E
Due to load sharing among the power supply outputs, the
maximum continuous current outputs of all voltages cannot be
achieved simultaneously.
Before installing other items, such as drives, add-in cards,
etc., connect a keyboard and a monitor to the system, switch
on and let the power-on self test (POST) run. This will be
followed by initialisation of the pre-installed Operating
System software, during which you will be asked to enter
personal registration details.
Once this has been fully completed, you can shut down the
operating software, turn the power off, then install any
drives, add-in cards, or upgrades, the instructions for which
are given in the following chapters.
This is to allow 'Plug and Play' add-in cards and their special
features to be correctly detected and configured.
Current (Max. continuous)
6.0 A
18.0 A
0.01 A
14.0 A
0.3 A
0.8 A