Mitsubishi Electric Apricot LS700 Owner's Handbook Manual page 82

B I O S a n d s e t u p
Primary/Secondary IDE Master/Slave Configuration
Subscreens
5/6 LS700 HANDBOOK
floppy drives. The following options change the access for
all attached floppy drives:
♦
Read/Write (default)
♦
Read Only
There are four subscreens used to enable IDE devices (e.g.,
hard disks):
♦
Primary IDE Master
♦
Primary IDE Slave
♦
Secondary IDE Master
♦
Secondary IDE Slave
Each of these subscreens contains the following eight fields.
IDE Device Configuration
Used to manually configure or autoconfigure the attached
IDE device. The options are:
♦
Auto Configured (default)
♦
User Definable
♦
Disabled
If you select User Definable, the Cylinders, Heads, Sectors
items can be specified. If you select Disabled, the BIOS will
not scan for a drive on that interface.
Cylinders
If IDE Device Configuration is set to User Definable, type
the correct number of cylinders for the installed hard disk.
If IDE Device Configuration is set to Auto Configured, this
field reports the number of cylinders for the hard disk.