Installing An Add-In Card - Mitsubishi Electric Apricot LS700 Owner's Handbook Manual

Installing an Expansion Slot Cover

Installing an Add-in Card

1. Observe the precautions in 'Before You Begin'.
2. Using a standard metal slot cover, insert the cover into
the slot.
3. Hold the slot cover bracket at an angle to the chassis
and line the holes in the bracket up with the tabs on
the chassis.
4. Pivot the bracket so the screw holes in the bracket and
the chassis line up (see Figure 8, A).
5. Secure the bracket to the chassis with two screws.
N N O O T T E E
Covers must be installed in all vacant slots to maintain the
electromagnetic emissions characteristics of the chassis and to
ensure proper cooling.
N N O O T T E E
The bottom slot will not accommodate a full length add-in card
1. Observe the precautions in 'Before You Begin'.
2. Remove the slot cover from the slot you wish to use.
3. Remove the card from its wrapper and place it on a
grounded, static-free surface.
4. Set any jumpers or switches on the card according to
the manufacturer's instructions.
5. Hold the card by the edges only and firmly press it into
the connector on the motherboard (see Figure 10).
6. Connect cables (if any are needed) to the installed card.
7. Replace the slot cover bracket (see Figure 8).
C h a s s i s a n d c o m p o n e n t s
LS700 HANDBOOK 2/9