Mitsubishi Electric Apricot LS700 Owner's Handbook Manual page 36

C h a s s i s a n d c o m p o n e n t s
Removing a Hard Drive from Behind the Power Supply
Installing a narrow Device in the main Peripheral
Carrier
2/18 LS700 HANDBOOK
W W A A R R N N I I N N G G
This procedure should be done only by qualified technical
personnel. Unplug the computer before doing the procedures
described here.
1. Observe the precautions in 'Before You Begin'.
2. Remove the non-access side panel.
3. Remove the power supply (see later in this chapter).
4. Disconnect the power cables and the ribbon data cables
from the drive.
5. Remove the three screws holding the drive to the
chassis.
6. Slide the drive out of the chassis and place it on an
antistatic surface.
7. Reinstall the power supply.
1. Observe the precautions in 'Before You Begin'.
2. Remove the main peripheral carrier as previously
described.
3. Remove the drive from its protective wrapper and place
it on an antistatic surface.
4. Set any jumpers, switches, or terminating resistors on
the drive according to the manufacturer's instructions.
5. Slide the drive into position. Line the screw holes on
the drive up with the holes on the carrier.
6. Insert and tighten four screws of the appropriate type
and length (not supplied).
7. Replace the peripheral carrier back into the chassis.